Application Type Bond, Seal, Hold, Mount 1 Part or 2 Part 1 Part Material Form Foam Tape Substrate Foam, Vinyl Manufacturer 3M Chemistry Vinyl, Acrylic Cure Method Pressure Sensitive Color Black, White Relative Solvent Resistance Chemical Resistance: Hydrocarbon solvent High Temperature Resistance (°C) 66, 93 Density (g/cm³) 0.320 Key Specifications TSCA
Technical Data for 3M 4416
1 Part or 2 Part
- 1 Part or 2 Part - 1 Part
- Tape - Foam Tape
- Other - Vinyl
- Pressure Sensitive (min) - Pressure Sensitive
- TSCA (Toxic Substances Control Act) - TSCA
Application Temperature (°F) 70 to 100
Shear Strength (psi) 500 (g), 125 (g) Test Method Tensile Strength (psi) 60 Test Method
UV Resistance UV resistance High Temperature Resistance (°C) 66, 93
Dielectric Strength (V/mil) 150 Thermal Conductivity (W/m°K) 0.06
Density (g/cm³) 0.320
Shelf Life Details 18 months from date of manufacture when stored in the original carton at 70°F(21°C) & 50 % Relative Humidity Shelf Life Temperature (°F) 70 Shelf Life Type From date of manufacture Shelf Life (mon) 18
Best Practices for 3M 4416
To obtain optimum adhesion, the bonding surfaces must be clean, dry and well unified. Some typical surface cleaning solvents are isopropyl alcohol and water or heptane.**Note: Be sure to follow the manufacturer’s precautions and directions for use when working with solvents.
Bond strength is dependent upon the amount of adhesive-to-surface contact developed. Firm application pressure develops better adhesive contact & thus improves bond strength.
Ideal tape application temperature range is 70°F to 100°F (21°C to 38°C). Initial tape application to surfaces at temperatures below 50°F (10°C) is not recommended because the adhesive becomes too firm to adhere readily. However once properly applied low temperature holding is generally satisfactory.
Comparable Materials for 3M 4416
Spec Engine® Results
Questions about this material?
Get personal assistance with your specific application needs.
Using LOCTITE® 454™ is a Valid Option for Engineers Working with a Wide Variety of MaterialsRead Article
Sylgard 184 by DOW is the Top Choice for a Transparent, Silicone Encapsulant. Read Why:Read Article
Shear Strength Test Methods
|Shear Strength||Type||Test Time||Test Temperature||Test Method|
|500 (g)||Static shear strength||360,000 sec||22°C||(As measured by static shear weight held for 100 hr)1/2 sq.in overlap|
|125 (g)||Static shear strength||360,000 sec||49°C||(As measured by static shear weight held for 100 hr)1/2 sq.in overlap|
Tensile Strength Test Methods
|Tensile Strength||Test Method|
|60 psi||(“T” Block) 1 in2 (6.45 cm2) Jaw Speed 2 in/min (50 mm/min)|