Brand Cytec Application Type Bond 1 Part or 2 Part 2 Part Material Form Liquid Substrate Glass, Metal, Plastic, rubber Industry Gears, Industrial truck tires Manufacturer Elantas (Altana) Chemistry prepolymer, semi-rigid urethane, PTMEG polyether Cure Method 2 Parts Cure Temperature (°C) 100, 100 Cure Time (min) 60, 960 Color Clear Light Amber
Technical Data for Elantas (Altana) RN-1520
- Adhesive - Bond
1 Part or 2 Part
- 1 Part or 2 Part - 2 Part
- Trucks - Industrial truck tires
- Other - Rolls, Die pads, Abrasion resistant belts
- Other - prepolymer, PTMEG polyether
- Polyurethane - semi-rigid urethane
- Dispenser - automatic metering, mixing equipment
- 2-Part Cure - 2 Parts
- Clear / Transparent - Clear Light Amber
Cure Temperature (°C) 100, 100 Cure Time (min) 60, 960 Work / Pot Time (min) 6 Mix Ratio 100:13.1 (by weight)
Structural/Load-Bearing High load-bearing Tear Strength (piw) 500 (pli) Tensile Strength (psi) 7,700, 950, 1,400, 2,100 Test Method
Abrasion Resistance Abrasion resistance Impact Resistance Impact resistance
Shore A Hardness 92 Shore D Hardness 40 Elongation (%) 460
Specific Gravity 1.060, 1.100 Test Method
Best Practices for Elantas (Altana) RN-1520
Pour mixed system into molds, preheated to 80°-100°C, that have been coated with CONAP® MR-5002 mold release or equivalent.
Automatic metering and mixing equipment can be used with this system.
Heat pre-weighed amounts of the CONATHANE® RN-1520 to 80°-100°C and degas at 1-5 mm of vacuum for at least 5 minutes or until excessive bubbling stops. Containers should be unlined metal, plastic, or glass and should be large enough to allow for foaming during degassing.
When adding MbOCA to RN-1520, the MbOCA must be melted at 120°C prior to mixing. After adding curative, mix thoroughly and degas at 1-5 mm for 1 to 2 minutes.
Comparable Materials for Elantas (Altana) RN-1520
Spec Engine® Results
Questions about this material?
Get personal assistance with your specific application needs.