Elantas (Altana) MR-5014
Brand Cytec Application Type Mold Release 1 Part or 2 Part 1-Part Material Form Liquid Manufacturer Elantas (Altana) Chemistry Water-based Cure Method Solvent Viscosity (cPs) <5.00 Color Off-white
Technical Data for Elantas (Altana) MR-5014
- Mold Release
1 Part or 2 Part
- Other - Cast Elastomers, Epoxies
- Spray - Light spray atomization
Viscosity (cPs) <5.00 Test Method
Specific Gravity 0.990 % Solids (%) 10
Shelf Life Details For best results store between 50°-80°F (13°-27°C). KEEP FROM FREEZIING!, Should CONAP® MR-5014 become frozen, thaw slowly. Gentle agitation for approximately 30 minutes will restore the material to a usable condition. Repeated freeze/thaw cycles will cause the mold release to be unusable. Shelf Life Temperature (°F) 122 to 176
Best Practices for Elantas (Altana) MR-5014
Thoroughly clean the mold with bead blast media, solvent and/or high pH detergent (or other means) to remove all traces of prior release agents and dirt build-up. Although CONAP® MR-5014 will work well on dirty tool, starting with a clean tool will provide the best results.
For best results, the tool should be above 180°F. Spraying is preferred over wiping the mold release onto the tool and will result in a more even coating. For spraying, use light spray atomization, applying three (3) light coats from different directions, allowing the film to dry between coats.
CONAP® MR-5014 should be mixed prior to use.
Comparable Materials for Elantas (Altana) MR-5014
Spec Engine® Results
Closest Results from this Manufacturer