ACL Staticide Staticide ACL 10R Primer for ESD Paint

Application

On surfaces apply ACL 10R primer using a brush, ¼” fine roller, squeegee or airless spraying equipment until the surfaces is fully saturated

however avoid puddling. Only one application is required. Remove all excess primer and trapped air by stroking applicator in tray before applying to surface. Allow 2-4 hours before applying any paint to the primer. For best results apply primer and paint at temperatures between 60ºF-80ºF. Allow 2 weeks drying time of paint before using a damp mop to clean coated floor. Do not use abrasive cleaners or scrubbing machines to clean the floor. Use sweeper or vacuum to clean the floor.

Mixing

Product is ready to use. Do not thin –mix prior to use. Prevent from freezing.

Clean-Up

Wash applicators with warm water and detergent immediately after painting.

Do not use abrasive cleaners or scrubbing machines to clean the floor. Use sweeper or vacuum to clean the floor.