Elantas (Altana) MR-5014

CONTACT REP

Description for Elantas (Altana) MR-5014

Environmentally friendly and provides excellent release for virtually all polyurethane materials as well as epoxy and other resin systems that require an external mold release.

*See Terms of Use Below

Brand	Cytec
Application Type	Mold Release
1 Part or 2 Part	1 Part
Material Form	Liquid
Manufacturer	Elantas (Altana)
Chemistry	Water-based
Cure Method	Solvent
Viscosity (cPs)	<5
Color	Off-white

Best Practices for Elantas (Altana) MR-5014

Register for FREE to view more details

Why register?

View Technical Details
View Test Methods
View Key Specifications
View Similar Materials
Save your Project Searches

See what Gluespec offers

Sign up now Already registered? Sign in!

Email: *

Password: *

Confirm Password: *

Do you prefer to see data in °F or °C?

First Name: *

Last Name: *

Phone: *

Company Name: *

Address: *

Postal Code: *

Country: *

Job Function: *

Industry: *

Describe: *

I agree to the terms of use *

*: Required

Technical Data for Elantas (Altana) MR-5014

*See Terms of Use Below

Overview

Application Type
- Release Agent - Mold Release
1 Part or 2 Part
- 1 Part or 2 Part - 1 Part
Material Form
- Liquid
Industry
- Industrial
- Other - Cast Elastomers, Epoxies
Chemistry
- Water-based
Application Method
- Spray - light spray atomization
Cure Method
- Solvent
Color
- Off-White
Brand
- Cytec

Specifications

Cure Specs

Viscosity (cPs)	<5	Test Method

Other Properties

Specific Gravity	0.990
% Solids (%)	10

Business Information

Shelf Life Details	For best results store between 50°-80°F (13°-27°C). KEEP FROM FREEZIING!, Should CONAP® MR-5014 become frozen, thaw slowly. Gentle agitation for approximately 30 minutes will restore the material to a usable condition. Repeated freeze/thaw cycles will cause the mold release to be unusable.
Shelf Life Temperature (°F)	122 to 176

Best Practices for Elantas (Altana) MR-5014

*See Terms of Use Below
1. Surface Preparation
  
  Thoroughly clean the mold with bead blast media, solvent and/or high pH detergent (or other means) to remove all traces of prior release agents and dirt build-up. Although CONAP® MR-5014 will work well on dirty tool, starting with a clean tool will provide the best results.
2. Application
  
  For best results, the tool should be above 180°F. Spraying is preferred over wiping the mold release onto the tool and will result in a more even coating. For spraying, use light spray atomization, applying three (3) light coats from different directions, allowing the film to dry between coats.
3. Mixing
  
  CONAP® MR-5014 should be mixed prior to use.
Comparable Materials for Elantas (Altana) MR-5014

*See Terms of Use Below

Spec Engine^® Results
- Elastosil Aux Mould Release Agent 32(Wacker)
  Wacker Elastosil Aux Mould Release Agent 32 is a 1 Part None Water-Based Liquid used to Release
- Conap Mold Release Agent(Elantas (Altana))
  A one component, water-based mold release agent.
- Pol-Ease 2601 Release Agent(Polytek Development Corp)
  A water-based silicone emulsion that can be brushed or sprayed into a polyurethane mold before casting concrete or plaster.
- Compare All